What are the holes in concrete fence posts for?
Timber or concrete posts
This is to allow drainage to take place between the post and the concrete.
Can you bolt fence posts to concrete?
The Fencebase Easy-Fit can be used on any surface which can accept bolts. These bases are the perfect answer if fencing posts or uprights need to be added to a completed deck surface or onto concrete, simply drill through the decking surface and attach with bolts.
What is a godfather fence post?
Used to support or repair timber posts. Each godfather has 3 holes to allow easy & secure fixing to the timber post. Always allow for 2ft to be sunk into the ground. Godfathers are traditionally secured using Coach Screws, going through the godfather and screwing into the timber post.
How deep should a concrete fence post hole be?
2 foot deep
Dig your hole to the correct depth, allowing for the height of the fence panel and the gravel board. As a rough guide the hole should be a minimum 1/3 the height of the fence, so a 6 foot fence would need an 8 foot post in a 2 foot deep hole.
Should pressure treated fence posts be set in concrete?
At Hercules Fence, we hear the same questions over and over, perhaps none more than “Should my Fence Posts be set in Concrete?” The simple answer is yes. It doesn’t matter if it is a do-it-yourself (DIY) project or a professional installation, wood fence or vinyl fence, your fence posts should be set in concrete.
How deep should a fence post be UK?
2 ft
Lawsons experts recommend you should dig a hole which has a depth of 2 ft (24 in / 600mm) to ensure you have a stable timber or concrete fence post.
How do you bolt a concrete post?
How To Install a Fence Post Onto a Concrete Base – YouTube
How do I attach a post to existing concrete?
How to attach wood posts / railing to concrete with Simpson Strong Tie …
What is DuraPost?
DuraPost® is a complete fencing system of steel fence posts and caps, corner posts, gravel boards and capping rails that can be used with both prefabricated fence panels and close board fencing with Arris, Cant or 3×2 rails.
How deep should a godfather post be?
Dig a hole around the Godfather fence post. The width and depth depend on the size of the fence post. Typically, you should aim for around 10cm deep and 8cm wide.
How many posts will a 20kg bag of Postcrete do?
depends how ‘good’ are your holes. you will need minimum 1 bag per post. I usually use one and a half per post but I am using 25kg bags. often poscrete is in 20kg bags so 2 per post is more likely.
Do you need gravel under concrete fence post?
DO Employ a Base Gravel Layer. If a fence post fails without any sign of a pest infestation, it’s likely that the failure was caused by moisture that rotted the wood over time. To help slow such deterioration, add pea gravel or crushed stone to the bottom of the posthole.
How long will a pressure treated post last in concrete?
A PT post will last a long time in concrete, maybe 5 to 10 years in soil alone. I suggest you embed the post in concrete, trowel a peak around the post so water runs off, and don’t let the PT post come in contact with the ground.
Can you put 6ft fence panels in 5ft posts?
6 foot into 5 foot posts should be ok, but you will need am infill panel inbetween the panels…. I’ve done this before by adding two strips of batten (or similar) down the edge of the panel to bring it proud of the post, then just add a piece of timber to cover the whole post and your 2 foot gap.
Can you screw directly into concrete?
Concrete screws are a quick and convenient way to fasten to concrete. The best thing about these screws is that you can screw directly into concrete without any need for hammering or an anchor or shield to install. All you have to do is drill a hole and drive in the screw.
How do you anchor bolts in concrete?
How to Anchor Bolts, Railings and Rebar in Concrete – YouTube
How do you anchor a 4×4 post to existing concrete?
How close to the edge of concrete can you put an anchor?
Don’t Drill too Close to Edges
To avoid these disasters, don’t drill any closer than 4 in. from the edge. If there’s no other option, turn off the hammering action on the drill. Also, avoid wedge-type anchors.
Are DuraPost any good?
DuraPost is stronger than both concrete and timber fence posts and is guaranteed to last up to 25 years. Made from galvanised steel, DuraPost doesn’t rot, split, warp, crack or chip and can even withstand winds of up to 110mph! It’s a no brainer if you ask us.
Are Dura posts any good?
Like concrete, DuraPost offers exceptional strength and durability. It’s guaranteed to last up to 25 years and withstands wind speeds of up to 110mph!
How do you keep fence posts from rotting in concrete?
Fill the first three inches up with gravel so the end of the post doesn’t come into contact with the dirt. Gravel allows water to drain quickly away from the post and into the soil. Be sure to place the post in the center of the hole. Finally, fill the entire hole up with cement to the top.
Is 2 feet deep enough for fence posts?
The depth of the hole should be 1/3-1/2 the post height above ground (i.e., a 6-foot tall fence would require a hole depth of at least 2 feet).
Can you over water Postcrete?
The thing is you can’t use too much water in a hole – even if you filled the hole to the top with water the postcrete will set.
Do fence posts need to be cemented into the ground?
No, fence posts don’t need to be set in concrete, and there are plenty of other ways to fix your posts if this feels a bit too permanent. If you are using wooden 4×4 fence posts, concrete may actually be the worst option.
Should fence post be higher than fence?
If you’re setting wooden or concrete posts in concrete you’ll need 8ft (2.4m) posts for a 6ft (1.828m) fence – i.e. your posts are 2ft (0.6m) longer than the fence height. Use 4in x 4in posts for fences of 5ft and over and 3in x 3in posts for anything under 5ft.